Electric Cleaning Kit Essential for Beginners

• Brand : Yeloly Doll
• Product : Electric Cleaning Kit
• Model number: : LLD-C001
• Condition : A brand-new, unused, unopened.

• Preparation Before Use : Insert the rotating rod into the main cleaning unit, ensuring it fits securely by pressing the corresponding notch. Pull it out vertically after use.
• Power On and Battery Indicator : Press and hold the button on the top for two seconds to turn on the device. If the battery indicator flashes, it means the battery is low. Please charge it before use.
• Charging Instructions :

Attach the magnetic end of the charging cable to the two metal points on the product handle, then plug the USB end into a phone charger. Charging voltage is 5V, charging current is 500mA, battery capacity is 1200mAh, and battery voltage is 3.7V. It takes about 3 hours to fully charge when the battery is empty.

Fully charged, the device can stay on standby for up to 8 months, with approximately 50 uses. Since charging intervals are long, please keep the charging cable safe.

• Usage Precautions : If the button is damaged or the unit has water inside, stop using it immediately. The device will automatically turn off if not used for 3 minutes after turning on.
• Water Temperature Indicator : If the water temperature exceeds 40°C, the temperature indicator will change from green to red. Please note that there is a delay in the temperature display, so rely on the actual feel of the temperature.
• Timer and Washing Mode : When you press the wash button, the timer indicator will show a red light for the first minute. After one minute of washing, it will turn green, and the washing will stop automatically.
• Function Switching : Press the button on the bottom once to start the water pumping wash mode. Press again to activate the rotating function, which will run for 65 seconds in both directions before automatically stopping. Press a third time to stop both the water pumping and rotating functions.
• Manual Mode : Press and hold the button on the bottom to enter manual mode. In this mode, the device will keep working continuously.
• Sterilization Function :

Insert the sterilization lamp's glass part completely into the silicone doll's vaginal cavity, then turn on the sterilization lamp. The lamp will light up to start UV sterilization, which takes 30 minutes.

After sterilization, the inside of the silicone doll will reach around 40°C. It’s safe for immediate use and has no side effects on the user.

• Post-Sterilization Cleaning : After sterilization is complete, turn off the power and then remove the sterilization rod.

Use the water-absorbing stick to remove any excess moisture from the silicone doll’s vaginal cavity. The absorbing stick is reusable. After use, allow it to air dry naturally.